Victron Energy Cable for Smart BMS CL 12-100 to MultiPlus – ASS070200100

£18.90

In stock

Product Description

This cable will allow the MultiPlus 500VA – 1600VA, MultiPlus Compact 800VA – 2kVA and MultiPlus-II models to be used with BMS products that have no VE.Bus interface, such as the Smart BMS CL 12-100 and the smallBMS. These MultiPlus models can be controlled from the Load/Charge Disconnect outputs and Load/Charger outputs respectively.

The cable must be wired to the remote on/off connector of the MultiPlus models:

• When used with the MultiPlus 500VA-1200VA models connect the black wire to the ON terminal and the red wire to the (+) terminal.

• When used with the MultiPlus Compact 800VA-2kVA models connect the black wire to the middle terminal and the red wire to the right (IN) terminal.

• When used with the MultiPlus-II models connect the black wire to the lower (-) terminal and the red wire to the upper (+) remote on-off terminal.

Both the Load/Charge Disconnect outputs of Smart BMS CL 12-100 and Load/Charger outputs of the smallBMS must be in ‘High’ state in order for the MultiPlus to operate. After shutdown due to low battery voltage, run the alternator or use a battery charger on the primary side of the BMS to reset the system. The MultiPlus will then switch on and start charging (if connected to an AC power source).

Additional Information

Brand

Victron Energy

Manufacturer Part Number

ASS070200100

GTIN

8719076051183

Warranty

5 Years

Country of Manufacture

India

Reviews

There are no reviews yet.

Be the first to review “Victron Energy Cable for Smart BMS CL 12-100 to MultiPlus – ASS070200100”

Your email address will not be published. Required fields are marked *

Victron Energy Cable for Smart BMS CL 12-100 to MultiPlus Manual – CLICK HERE