Victron Energy Smart Battery Protect 12/24V 220A - BPR122022000

Victron Energy Smart Battery Protect 12/24V 220A - BPR122022000

CALL US 01684 298 800

Victron Energy Smart Battery Protect 12/24V 220A - BPR122022000

Victron Energy Smart Battery Protect 12/24V 100A - BPR110022000

Victron Energy Smart Battery Protect 12/24V 100A - BPR110022000

Victron Energy Smart Battery Protect 48V 100A - BPR110048000

Victron Energy Smart Battery Protect 48V 100A - BPR110048000

£107.71
Availability: In stock
SKU
BPR122022000
Rating:
100% of 100
  • BPR122022000
  • Victron Energy
  • Battery Management

The Smart BatteryProtect disconnects the battery from non-essential loads before it is completely discharged (which would damage the battery) or before it has insufficient power left to crank the engine.

When using Bluetooth to program the Smart BatteryProtect any required engage/disengage levels can be set. 
Alternatively, one of nine predefined engage/disengage levels can be set with the programming pin (see manual). 

If required, Bluetooth can be disabled.

Protects the battery against excessive discharge and can be used as a system on/off switch

The Smart BatteryProtect disconnects the battery from non-essential loads before it is completely discharged (which would damage the battery) or before it has insufficient power left to crank the engine. The on/off input can be used as a system on/off switch.

12/24V auto ranging

The Smart BatteryProtect automatically detects system voltage one time only.

Bluetooth: programming made easy

When using Bluetooth to program the Smart BatteryProtect any required engage/disengage levels can be set. Alternatively, one of nine predefined engage/disengage levels can be set with the programming pin (see manual). If required, Bluetooth can be disabled.

A special setting for Li-ion batteries

In this mode the BatteryProtect can be controlled by the VE.Bus BMS. Note: the BatteryProtect can also be used as a charge interrupter in between a battery charger and a Li-ion battery. 

Ultra-low current consumption

This is important in case of Li-ion batteries, especially after low voltage shutdown. Please see our Li-ion battery datasheet and the VE.Bus BMS manual for more information.

Over voltage protection

To prevent damage to sensitive loads due to over voltage, the load is disconnected whenever the DC voltage exceeds 16.3V respectively 32.6V.

Ignition proof

No relays but MOSFET switches, and therefore no sparks.

Delayed alarm output

The alarm output is activated if the battery voltage drops below the preset disconnect level during more than 12 seconds. Starting the engine will therefore not activate the alarm. The alarm output is a short circuit proof open collector output to the negative (minus) rail, max. current 50 mA. The alarm output is typically used to activate a buzzer, LED or relay.

Delayed load disconnect and delayed reconnect

The load will be disconnected 90 seconds after the battery voltage drops below the preset level. If the battery voltage increases again to the connect threshold within this time period (after the engine has been started for example), the load will not be disconnected. The load will be reconnected 30 seconds after the battery voltage has increased to more than the preset reconnect voltage.

More Information
SKU BPR122022000
Manufacturer's Part Number BPR122022000
Description Smart Battery Protect 12/24V 220A
Length (mm) 120
Width (mm) 123
Height Inc Terminals (mm) 62
Weight 0.8
Volt 12/24V
AH 200A
Warranty 5 Years
Layout RH+
Write Your Own Review
You're reviewing:Victron Energy Smart Battery Protect 12/24V 220A - BPR122022000
Your Rating